PRESETFERRY GUIDES · UPDATED NOVEMBER 17, 2026

POD Go and Helix Preset Files Explained

Understand preset files, signal paths, snapshots and impulse responses before moving your sounds between devices.

What is inside a preset?

A preset describes a rig: the blocks it uses, their order, parameter settings, bypass states and control assignments. A snapshot stores a variation of that rig. It can change supported settings and block states without replacing the entire preset.

Presets, setlists and backups

DevicePresetSetlistBackup
POD Go.pgp.pgl.pgb
Helix.hlx.hls.hxb

A preset is one sound and its snapshots. A setlist groups presets. A backup can contain additional device data and dependencies. Changing a filename extension does not convert its contents.

Blocks and signal paths

Blocks represent amps, cabinets, effects and other parts of the rig. Routing determines how audio reaches them. Putting a delay before an amp is different from putting it after the amp; blending two parallel paths is different from connecting those effects in series.

Snapshots are settings, not separate rigs

POD Go provides four snapshots per preset. Each can remember bypass states and assigned parameter values. A snapshot cannot replace one amp model with a different model or rearrange the signal chain. Both required blocks must already exist if a scene switches between them.

A small structural example

{
  "name": "Example clean tone",
  "blocks": ["compressor", "amp", "cab", "delay"],
  "snapshots": [
    {"name": "Verse", "delay_on": false},
    {"name": "Chorus", "delay_on": true}
  ]
}

This invented JSON illustrates the idea only. It is not a valid Line 6 preset, a complete file specification or an importable download. Real exported files use device-specific identifiers, nesting and metadata; these can vary with firmware.

An IR reference is not the IR audio

An impulse response (IR) supplies cabinet or other response audio. A preset can point to an IR slot without including that audio. The right slot number alone is not enough: the destination needs the correct IR, and existing slot contents matter.

Further reading

Keep exploring

Open the converter →